BarTender Designer 2022 R8 - Multiple Templates Issue / Questions

Landon Alboro

• 24. Februar 2025 22:23
• Bearbeitet

Hello,

I am trying to configure my label printing setup to achieve the following:

• The destination label should always be printed no matter what.
• The mixed load label should be printed but only if two or more master labels are being printed. If only one master label is present, the mixed load label should not print.

 

I have my page setup like this

 

I have attempted to achieve this using the "Print When" condition based on a data source, but I have not been successful.

Any assistance would be greatly appreciated.

Thank you!

 

 

0

• 

  Peter Thane

  ★ BarTender Hero ★

  • 27. Februar 2025 09:33

  This is how I have set this up on a test label:

  • Use the button to the right of Copies to set this Value to come from a Data Source and make this Data Source Named 

  

  

  • Data an Entry field to a Data Entry form and link it to the Named Data Source/Copies

  

  • In the page Setup, adjust the Print When to Your Named Data Source is equal to or greater than 2 and that should do it

  

  Value of 1:

  

  Value set as 3

  

   

  0
• 

  Landon Alboro

  ★ BarTender Hero ★

  • 3. März 2025 20:47
  • Bearbeitet

  Hey Peter,

  Thank you a lot! I recently figured this out. Basically what you said worked. 
  
  However I have another question maybe you could answer.

  I figured out how to print all my templates all at once. Meaning
  Destination Label (Prints always), Mixed Load (If Needed), Master (Prints always), Carton Label(2 Per. Otherwise based on selected records)

   

  Whenever I print they end up like this (Note the 1 2 3 are the same label a total of 9 labels shown.)

  
  
  They're all shown correctly how I want them but. Is there a way that it will show all the master labels first, then all the carton labels?
  Shown Above:
  Destination, Master 1, Cartons 1, Master 2, Cartons 2

   

  Something like this: But will always 100% of the time print the master label first

  

  Shown Above: 
  Destination, Master 1, Master 2, Carton 2.
  
  Is there a way to make it so it will always print masters first before cartons
  
  Example: This example I didn't need the cartons for Master 2.

  Destination Label, Mixed Load (If Needed), Master 1, Master 2, Master 3, Master 4, Carton 1, Carton 3, Carton 4. 

   

  Any tips or advice would be very helpful! Thank you.

  0

Bitte melden Sie sich an, um einen Kommentar zu hinterlassen.