Saltar al contenido principal

Búsqueda

Búsqueda

Teclabel dt039-50 Printing error related to paper bands

Comentarios

3 comentarios

  • Avatar
    Peter Thane

    The black mark is the registration mark the printer uses to tell it when the next label starts and although you could set a small top of form type adjustment this will only give you a few millimetres adjustment and so it may not be possible to do what you are trying to achieve

    0
  • Avatar
    Vicente del Rio

    Before a few days was posible, I was use printing with the label in the center, but starting yesterday something happend and I had to calibrete it again. From that day foward it started to print wrong. I will shere you some img's about it. 

    This is what I am trying to print, as you see I want to print the label in the center.

    The configure options.

    This is the paper band

    As I told you before, for a long time It was print like this

    But starting yestarday I had to recalibrate it and it started to print like this:

     

    And some like this:

    I hope with this I made clear the problem.

     

    0
  • Avatar
    Peter Thane

    I wonder if the printer was set to Gap/Web sensing previously with the label sensor positioned so that it picks up where the notches are, ie 

    You could try adjusting the media type in the page setup to the this from the default "Use Current Printer Settings" that your config is using and see what that does

    0

Iniciar sesión para dejar un comentario.