Saltar al contenido principal

Búsqueda

Búsqueda

Slow printing with Date Picker

Comentarios

3 comentarios

  • Avatar
    Peter Thane

    Two things you could try/check, is make sure you are using a Seagull and not the ZDesigner driver and also look at the font being used and change to one of the Zebra (Triumvirate or similar) as TrueType font fields are handled as graphics.

    0
  • Avatar
    Tom Helley

    Thank you very much for the reply Peter. I was able to resolve this issue on my own. What I didn't think about yesterday was how the printers are connected to the computers. They're direct connections, not networked, so I didn't think it would be an issue. This morning I decided to check and they were using old 9-pin serial cables. I swapped them out with USB's and now they print fine.

    0
  • Avatar
    Peter Thane

    No worries but that probably is to do with the fonts then as the files will be going down with graphics and so will be a lot bigger than normal than if using the devices fonts and so this really can be slow with serial connections.

    0

Iniciar sesión para dejar un comentario.