Saltar al contenido principal

Búsqueda

Búsqueda

Offset printer

Comentarios

4 comentarios

  • Avatar
    Peter Thane

    I had something similar with a different model of Sato but this was the start of print position on the left/inner edge of the label and was something physical in the printer rather than software/driver settings. 

    I would suggest trying to adjust the offset in the printer driver itself in Control Panel rather than in BarTender. I think you may need to tweak the Horizontal offset as shown here:

     

    0
  • Avatar
    Michael Finch

    I tried this, but after adjusting this setting, the label no longer stops at the edge of the printer. I moved the test about 0.5", and not the printer stops with the label about 0.5" from where it should stop. I think that because this moves the print location off the label, the printer continues moving beyond the margins of the label.

    0
  • Avatar
    Michael Finch

    each pair of printers prints 4 different label types, with text in different positions. since the label stops at a different position for each, depending on how far the offset makes the text move outside the margin. I can't just make the printer backup a fixed distance. This will be especially confusing for the end customer in the future if they need to make a change.

    0
  • Avatar
    Michael Finch

    I'm feeling dumb. I found a setting that was different in the other printer that is part of the pair. Auto Backfeed was set to 2mm and was causing the printer to print text in the wrong position. When I set it to "default", the text appeared exactlly where it should. Solved

    0

Iniciar sesión para dejar un comentario.