Saltar al contenido principal

Búsqueda

Búsqueda

cab squix 4 / 300mt when I continue to print 2 jobs, 1 label is empty, very wasteful, I want to print 2 more jobs without any blank labels

Comentarios

1 comentario

  • Avatar
    Peter Thane

    It sounds like it could be a label configuration issue of some kind. 

    You may want to check that you gave selected the correct label sensor for the printer to use and also check the page setup. 

    For the width of the "page" of a label, the width should be the full width of the label roll including the backing material to the right and left of the label. The margin settings are what allow for this backing paper. However for the height the gap between then labels is not accounted for as the printer itself pick up on this and so you need to make sure the height of the label in BarTender is the correct setting for the labels you are using.

    0

Iniciar sesión para dejar un comentario.