Label Feeds into next label

Lloyd Kenney

• 22 août 2023 18:37

The printer prints the label correctly but over feeds into the next label. How do I stop the feed from over feeding into the next label?

 

Thanks

0

• 

  Peter Thane

  ★ BarTender Hero ★

  • 23 août 2023 08:21

  That sounds like it could be a label design issue with the height being too high.

  With gap labels although for the width you need to set a left and right margin that allows for the backing paper (gutters) either side of the label, for the top and bottom you need to make sure the printer is configured to Gap sense mode and allow the printer to pick up on the gap. This means that the height of the label in the label setup is the actual height of the label with no top/bottom margin set. 

   

  0

Vous devez vous connecter pour laisser un commentaire.