Trouble Positioning Labels Correctly.
We have the B-SA4T-T at our office and use it to print labels. However, this week the PC we have Bartender installed on is running into problems with its hard drive starting to fail so we've installed the software on a freshly formatted PC, same specs.
The problem is with this new PC is instead of first spooling backwards to get the label into the right position to print, then print the label and then spool a little forward in order to tear it in the correct place, it just kinda spits out the label straight off, no spooling forward or backwards other than the print itself.
We've recently tried the printer again on the older PC (I can't see it lasting much longer, its taking forever to boot) and the labels print fine. We've checked and compared all settings between the two PC's and both are identical, so we've no idea what's causing this problem. Please help!
The problem is with this new PC is instead of first spooling backwards to get the label into the right position to print, then print the label and then spool a little forward in order to tear it in the correct place, it just kinda spits out the label straight off, no spooling forward or backwards other than the print itself.
We've recently tried the printer again on the older PC (I can't see it lasting much longer, its taking forever to boot) and the labels print fine. We've checked and compared all settings between the two PC's and both are identical, so we've no idea what's causing this problem. Please help!
0
-
Hi. Have you installed your printer using Seagull drivers? If not, it's always best to start with that.
The feed/spooling thing is usually controlled by the print method. This can be set from the document properties > Stock tab (see attached image). Try different settings to see if you can match what you had before.
If otherwise, the label isn't lining up, confirm the printer is calibrated. If it's printing offset the same amount on every label, take advantage of the "Set Top Adjustment" option at the bottom of the stock tab (Refer to attached image again).0 -
nRyder you are a legend! That worked brilliantly! For some reason the old PC had the original settings, but we changed a few things in the options and the last one worked!
Thanks ever so much.0
Vous devez vous connecter pour laisser un commentaire.
Commentaires
2 commentaires