Intergration Builder With Serialization Transfrom S’abonner

0
Avatar
Doug Gerlach

I have a Label btw file that has a 2D barcode which one of the field has a serialization transform of "Increment by 1 every page, numeric, rollover limit 999 reset to 100".  When i print from Bartender Designer, and print 3 labels, the serial number increments by 3, and the next time I print 3 labels, it prints from 103 to 105, which is what I would expect.  When I use the label in integration builder, and print 3 labels, starting from serial 103, it prints 103 to 105 like I would expect.  When I print another 3 from integration builder, it print the same 103 to 105 serial numbers, like it never updated where it was in the increment position for the serialization transform.  Is there something additional I need to configure for this to save the serial number when printing from integration builder?

 

 

3 commentaires

0
Avatar
Pete Thane
Actions pour les commentaires Permalien

Hi,

I assume this is ticked:

 

If so have you tried configuring Integration Builder to run under a different User account in the event it is a permissions issue? This option can be found on the Actions tab in Integration Builder.

Alternatively you could try setting the serial; number field as a Global Data Field.

Pete 

0
Avatar
Steve Smith
Actions pour les commentaires Permalien

Did anyone get this working?  I have the issue whereby the Serial starts at 1001 and increments by 1 so 5 labels would start at 1001 and finish at 1005.  The next print job should start at 1006 but it goes back down to 1001.  I have selected the option to save the document after print job and even used a Global data field instead of embedded but it still resets the serial after every print.

0
Avatar
Pete Thane
Actions pour les commentaires Permalien

Yes it works for me just using the save as option highlighted above. 

I am running it all locally rather than connecting to any network drives so it could be a permissions issue. You could try settings some specific User Credentials in the Action tab of the Print Document action as normally Integration Builder will use a Local System account and so may not sufficient permissions to be able to save the file. 

Vous devez vous connecter pour laisser un commentaire.