Label size accuracy S’abonner
Hi everyone, currently using v10.1 and I was just wondering if there is any way to allow dimensions to be specified to 2 decimal places? or if this has been added to a newer version.
Normally working to 1 decimal place is not a major problem when setting up label templates, but i have recently had a job that is on a 203.2mm page, the label size is 45mm wide, 5mm high with a 5.16mm gap 20 labels per page.
At the moment i can either set my label gap to 5.1 or 5.2mm the problem is that this leads to a 1.2mm run out over the page (20 labels) on a larger label this wouldn't be too much of an issue, but when the label is only 5mm high, 1.2mm is quite noticeable.
Vous devez vous connecter pour laisser un commentaire.