跳至主內容

搜尋

搜尋

Label Feeds into next label

評論

1 條評論

  • Avatar
    Peter Thane

    That sounds like it could be a label design issue with the height being too high.

    With gap labels although for the width you need to set a left and right margin that allows for the backing paper (gutters) either side of the label, for the top and bottom you need to make sure the printer is configured to Gap sense mode and allow the printer to pick up on the gap. This means that the height of the label in the label setup is the actual height of the label with no top/bottom margin set. 

     

    0

登入寫評論。