Label Taken Sensor

Legacy Poster

• 2015年05月06日 12:33

Hi all,

 

I have Zebra ZT230 and im very statisfied with the seagull bartender software.

But on my previous software, the printing paused after each label (depending on which label), untill the label was taken, then the printer printed the next one.

 

This should also be possible with the bartender software. Using the "meadia handling" tab, then the "action", then "wait for label taken sensor".

 

Here is the problem: i cant select the "wait for label taken sensor". The only items i can select are: "Use driver settings", or "Page-break" (might be slightly different naming in english because i have the dutch version of bartender)

 

I tried a lot but with the same result... no pause between printing label. There is a gab between each label and the printer does detect that gab. And the zebra does pause with the other software...

 

Any suggestions?

 

Thx!

0

• 

  Legacy Poster

  ★ BarTender Hero ★

  • 2015年05月14日 19:02

  nobody :s?

  0
• 

  Shotaro Ito

  ★ BarTender Hero ★

  • 2015年05月15日 06:02

  Do you use ZDesigner / Nicedriver?

  Install Seagull driver for Zebra and try again. For USB printer, you might need to update driver from Printer Properties > Advanced > New driver (specify C:\Seagull folder).

  0
• 

  Legacy Poster

  ★ BarTender Hero ★

  • 2015年05月16日 18:00

  thx, i already tried that and it didnt work but now i retried and appearantly i didnt do it right cuz now IT WORKED! thx !

  0

請登入寫評論。