Barcode Print On Different Printers 追蹤

0
Avatar
Legacy Poster

My company has two offices, the head quarter has CITIZEN CLP-631/CLP-6002/CLP-7202e, the other office only has CITIZEN CLP-631. We designed a product label with barcode on CLP-7202e for both offices. It works fine on both 6002 and 7202e, but when we print it on CLP-631, the barcode is squeezed and become unscannable. The centralized text is also towards to left a little. And if I select different printers, the design view will be different.

I know some printing are base on the selected printer and resolution. I tried to use CLP-7202e printer setting to override the CLP-631 manufactory default. It can make the design view be the same when I select different printers, but when I print them out on the printer, it didn't change anything. I was wondering if there is any way to make the CLP-631 print the label the same as CLP-7202e does?

 

Thanks a lot.

2 意見

0
Avatar
Ian Cummings
版主
評論操作 永久連結

1. When it comes to 200 and 300 dpi printers it really isn't possible to get the same X-dimension on the overall barcode.  This is because the printer resolution plays an intrinsic part in defining the X-dimension of the barcode as a whole.

 

Assuming you're using a recent version of BarTender, you can click the properties button of the X-dimension value, and from the dialog that opens, specify a target X-dimension that the barcode should conform to.  In this way you can control with a little more intelligence the X-dimension that is used when the document is used with a 300 dpi printer.

 

2. You can make an adjustment to print offset via the "Print" dialog, "Document Properties" button, "Page Setup" tab, "Advanced Options" button, and then under the "Printing Position" tab you can set a horizontal offset as needed.

 

3. Note that the unprintable width specified in the driver means that you may not have a left hand margin that is less than this value in the documents page setup.  You can reduce the unprintable margin if you want, but Citizen doesn't guarantee that anything will print within that area.  This is part of their manufacturing tolerance on the print head.

 

 

0
Avatar
Legacy Poster
評論操作 永久連結

I increased the locked target x dimension a little, it doesn't change the actual x dimension on CLP 7202e but enlarge it on CLP631. I was expecting to make the actual x dimension on both printers but it looks it's impossible.The label printed CLP631 can barely hold the longest PN barcode. But anyway it's scannable .

Thanks a lot. :)

登入寫評論。