Printing Problem, Fed Up 追蹤

0
Avatar
Legacy Poster

Hi

   I m using Bartender Single user Automation My Problem is that only first page of labels print at accurate place other job goes down and all labels are disturbed i m using TSC 244 Plus. media is properly calibrated, u can understand my problem better after seeing images attached, when i move my stuff upwards on template it overlaps bars and human readable, pleeeeeeeeaaaaaaaaaase Helppppppppppppp

2 意見

0
Avatar
Ian Cummings
版主
評論操作 永久連結

Assuming the labels to be 19mm in height, you should set the page height to also be 19mm and the top and bottom margins to zero.  The printer, if properly calibrated, will index over the gap for you.  In the printer driver, opened via the BarTender "Print" dialog and then click on the "Document Properties" button, make sure that the sensor type selected is gap sensing, and that any related setting like offsets are configurered correctly.

0
Avatar
Legacy Poster
評論操作 永久連結

solved, Thanks v much, i thought that template size page setup set in bartender and all is done, i was wrong. i didnt knew abt offsets. everything has been set after setting offsets

登入寫評論。