Problem with Printing label on Toshiba B-SA4T
Hi,
I was trying to print from B-SA4T. The size of the label is 90mm x 61mm (3.5” x 2.4”). Semi-gloss Blank Label Round corner, 3"paper core.
I don't understand why the label print start off 1 inch after the label. It is not printing the label directly on the label and printed half of the label to another. Here is my setting and printout of the label
-
I found out I can't change to 90mmx60mm. After I change, it was back to 90mmx90mm. I have page width and height exceed manufacturer-specified limits.
How can I change this.
0 -
After looking at https://support.seagullscientific.com/hc/en-us/articles/115014912628-How-to-modify-a-printer-s-manufacturer-specified-page-size-Limits
The minimum size of the label changed and result is still the same.
0 -
For the page limits, make sure you haven't changed anything on here:
By default the sensor setting in the Seagull driver is set to none and so you should adjust this to Transmissive to enable the gap sensor in the printer
0
請登入寫評論。
評論
3 條評論